Women's dress pattern A0004

Сукня А0004

The patterns are suitable for fabrics such as denim and linen.
!!!Before cutting, it is recommended to pre-shrink (decatize) all fabrics so that any shrinkage occurs prior to garment cutting.
The dress features an A-line silhouette, without a closure, and is knee-length. The neckline is round, with a small decorative V-shaped slit at the front. The neckline and armholes are finished with facings (the facings are interfaced with fusible interfacing).
The dress includes bust darts and has center seams on both the front and back. The back features a yoke. A decorative panel is attached along the hem of both the front and back.
The dress has decorative topstitching in a contrasting color along the neckline, armholes, darts, back yoke, center seams of the front and back, the hem of the front and back, and along the seam where the decorative panel is attached, using decorative threads.
The hem is finished with a turned-up hem. Seam allowances: all main seams — 1.0 cm, neckline and armhole facing seams — 0.7 cm, hem allowance — 3.0 cm.

Women's standard sizes

To determine your size and choose the correct pattern size, compare your key measurements (bust, waist, and hip circumference) with the size chart below.

What You Receive

Immediately after payment, you will receive a ZIP archive. The archive must be extracted and downloaded to your device.

The folder includes:

1. Technical Documentation:

• technical drawing
• construction of pattern pieces and assembly details
• womens standart sizes
• material consumption table and recommendations
• finished garment measurement table (based on patterns)
• table of pattern part names
• pattern piece layouts/illustrations
• fabric layout plans by size for fabric width of 140 cm
• layout scheme for printing PDF patterns on A4 sheets with instructions

2. Patterns in the selected format with seam allowances indicated, including grainlines and notches for accurate assembly:

• PLT format patterns – for plotter printing (working width 140 cm), including a 1 m × 1 m calibration square file for plotter setup (not intended for printing)
• PDF format patterns – for A4 printer printing, including a 10 cm × 10 cm calibration square for printer setup